LED Wizard 8 Documentation

Previous  Next

7.26 LED Object Property Bar

This property bar is customized for LED Objects. It shows additional data specific to LED objects, including:

There's a blank area after Runs that will show an errors in looking up density when scaling an LED Object

Some fields will be grayed out and disabled when Dynamic is not enabled for LED objects: H (height), W (width) and the first box from the left, Scale.

Scale

Enter a new scale factor to apply to the graphic.

H - Height

This is the height of the object, which you can change with a new value here.

W - Width

This is the width of the object, which you can change with a new value here.

X - Horizontal Position

This is the horizontal value of the current "anchor", which defaults to the lower left. See Anchor below.

Y - Vertical Position

This is the vertical value of the current "anchor", which defaults to the lower left. See Anchor below.

Name

Enter the name of the object here. For letters, this is just what the letter is, like "A".

Stroke Width

The calculated stroke width of this letter.

S/W % - Stroke Width Percentage

This is the stroke width as a percentage of the total height

Clearance

This is the clearance from the edge as looked up in the density table for the current module and can depth

Runs

This is the total number of runs as looked up the density table for the current module and can depth



Previous  Next

Copyright (C) 2019-2025 Principal Industries